Was wondering if any one had an idea here.When I put my tube through my backer I put it in on an angle on both sides so I can come out wrap my line and finish threading through.The problem I get is my float has that curve in it from being spooled to package.If I run the tube straight through it stays straight.Not only that but I don't like the idea of the tube being on an angle.But I like wraping it to keep it fixed..Any ideas?TM

------------------
"Just say HELL no to sovereign nation!!!!!"

Try to lay the backer rod down flat for a few days before using it,it may help!!
Good luck,
STRIKE ZONE