#257242 - 10/06/04 09:34 AM
Motors for Drift Boats
|
Smolt
Registered: 04/25/99
Posts: 74
|
I'm looking for a new motor for my 17' drift boat. I can't decide between the small 2-4 HP 4 stroke gas motors, or the 74 or 101# Minn Kota Vectors. Opinions from others using any of the above would be greatly appreciated. If you have an electric, how well does it push/pull your boat, and do the batteries last for a full day of fishing? Thanks for any info!!
|
Top
|
|
|
|
#257243 - 10/06/04 11:31 AM
Re: Motors for Drift Boats
|
River Nutrients
Registered: 04/25/00
Posts: 5006
Loc: East of Aberdeen, West of Mont...
|
Just some comments: 1st let me tell you my boat is a small jet boat, but that being said......I have an Minnkota 50, 2 batteries, and a switch to go from 1 battery to the other. The extra weight of the batteries, is more than some of the 4 stoke motors weight. The charging gets to be a pain, and bottom line they just don't have as much power. I'm seeing more and more driftboats, with small power motor..........that's the way I'd go and will in the near future........ "Worse day sport fishing, still better than the best day working"
_________________________
"Worse day sport fishing, still better than the best day working"
"I thought growing older, would take longer"
|
Top
|
|
|
|
#257246 - 10/06/04 05:00 PM
Re: Motors for Drift Boats
|
Three Time Spawner
Registered: 02/24/00
Posts: 1516
|
one of my fishing partners just bought a 6hp 4 stroke yamaha for his drift boat.. it works great and were haveing a great time with it..
_________________________
Where Destroying Fishing in Washington..
mainly region 6
|
Top
|
|
|
|
#257249 - 10/06/04 10:58 PM
Re: Motors for Drift Boats
|
Juvenile at Sea
Registered: 03/03/02
Posts: 240
|
i have a 6hp 2 stroke on my 16 ft does great.I ll be getting a electric for the low water steelhead soon also.The 6 does good remeber you can only push those drifters so fast they just are not meant for high speed
_________________________
see ya on the water.
|
Top
|
|
|
|
#257250 - 10/06/04 11:36 PM
Re: Motors for Drift Boats
|
Smolt
Registered: 06/26/01
Posts: 79
Loc: Eugene,Or.
|
Used a 7.5 long shaft merc. for 22 years. Now use a 8hp. long shaft honda or a 36lb. thrust minn kota depending on type of water.
|
Top
|
|
|
|
#257253 - 10/07/04 11:43 PM
Re: Motors for Drift Boats
|
Juvenile at Sea
Registered: 03/28/00
Posts: 222
Loc: Renton,WA
|
One thing to think about is if you put a gas powered motor on a boat you have to license tha boat. And if you did'nt pay sales tax on your boat you'll have to do it then. I bought my Willie boat in Oregon new and to license the boat it would have cost me $400 plus to use a motor a couple times a year. For me anyway it was a waste of dollars at that time.
I don't know if they would tax you on the price on the title when it was put in your name or the current value.
If you have already paid the tax you'll be good to go.
|
Top
|
|
|
|
#257254 - 10/08/04 12:41 AM
Re: Motors for Drift Boats
|
Eyed Egg
Registered: 09/05/04
Posts: 8
Loc: Junction CIty, OR
|
I have had a 4 hp. 2 cycle Yamaha on a 16 ft. wide bottom koffler. it was light and had an internal tank. i had no problems with power. because it was an internal tank, there wasn't a tank to kick around on the floor. It would run for 2 trips on 1 tank. BTW it was a short shaft in a motor well.
|
Top
|
|
|
|
#257255 - 10/08/04 09:54 AM
Re: Motors for Drift Boats
|
Repeat Spawner
Registered: 09/23/02
Posts: 1188
Loc: Monroe, Washington
|
Early one morning I got up and American Outdoor Journal was on TV and they were fishing the Rogue River for Kings. It was a North River drift boat with a kicker motor. They got some really nice kings and when they were done they fired up the motor and went back up river! This was really slick. Never seen this done.
_________________________
Join the Puget Sound Anglers Sno-King Chapter. Meets second Thursday of every month at the SCS Center, 220 Railroad Ave. Edmonds, WA 98020 at 6:30pm Two buildings south of the Edmonds Ferry on the beach.
|
Top
|
|
|
|
#257256 - 10/08/04 10:00 AM
Re: Motors for Drift Boats
|
Repeat Spawner
Registered: 03/30/02
Posts: 1395
Loc: Lake Stevens
|
Does anyone know what is the largest outboard you can use on a 16 ft drift boat? I know the design only allows them to go so fast, so I wouldn't want to get a motor that is too large.
_________________________
Go Dawgs!!! Fishing MVP
|
Top
|
|
|
|
#257257 - 10/08/04 11:12 AM
Re: Motors for Drift Boats
|
Smolt
Registered: 06/26/01
Posts: 79
Loc: Eugene,Or.
|
IMHO no reason to go more than 8hp.
|
Top
|
|
|
|
#257258 - 10/09/04 12:34 PM
Re: Motors for Drift Boats
|
Alevin
Registered: 01/19/04
Posts: 13
Loc: Edgewood, Wa.
|
FISHNBRAD, I thought you didn't have to license a boat if you have a motor under 10hp. I was told this is why everybody makes a 9.9 hp. Any body know for sure? I have a 9.9 hp 4 stroke merc and it's too heavy for my 16x54 Alumaweld. A 6-10hp 2 stroke is what I'm looking for.
|
Top
|
|
|
|
#257259 - 10/10/04 12:41 AM
Re: Motors for Drift Boats
|
Juvenile at Sea
Registered: 03/28/00
Posts: 222
Loc: Renton,WA
|
This is from the DOL web site. What size boats with a motor are required to be registered? All vessels with propulsion machinery are required to be titled/registered including sailboats 16 feet and over without any propulsion machinery. For information on other exemptions, please contact your local county auditor's office or closest vehicle licensing office. Here's the link http://www.dol.wa.gov/vs/vs-faq.htm#size I wish it wasn't the case, but there gonna get us any way they can.
|
Top
|
|
|
|
|
1 registered (Salmo g.),
932
Guests and
2
Spiders online. |
Key:
Admin,
Global Mod,
Mod
|
|
11499 Members
17 Forums
72932 Topics
825086 Posts
Max Online: 3937 @ 07/19/24 03:28 AM
|
|
|