#97399 - 10/09/00 07:56 PM
Re: Rigging Kwikfish
|
Fry
Registered: 09/03/00
Posts: 33
Loc: Yolo, Ca. USA
|
If you need to go to a single hook on your kwikfish you can clip off two of the hooks from each treble...then smash the barb down on the remaining hook. Leave the hook on the part of the treble facing down!! Not sure if this would be legal where you are fishing but I have found that this makes the flatfish or kwikfish easier to tune when compared with using single siwash hooks.
|
Top
|
|
|
|
#97400 - 10/09/00 08:36 PM
Re: Rigging Kwikfish
|
Alevin
Registered: 09/08/00
Posts: 17
Loc: warren, Or.
|
Try this: Back out the screwed eye hooks. Open up the eyes.Remove treble hooks and rings. Slide on a #10 or #8 McMahhaon barrel swivels.Squeeze shut.Dab your threaded screw eyes in super glue. Screw back in.Attach a Gami 4/0 single siwash hook to both barrel swivels. Dump overboard for fun.
This is probably better than the double split ring rig. It extends the hook back further. It stops the split rings from meshing and cocking your hooks at an odd angle when back trolled. It also allows the hook to spin free with the fish during battle, eliminating any hook prying , bad angle, leverage attempt by the fish. It works well for me. I believe it has substantially increased my sack-em rate over the past 10 years. Watch me miss the next ten takedowns , now....
|
Top
|
|
|
|
#97401 - 10/10/00 06:20 AM
Re: Rigging Kwikfish
|
Anonymous
Unregistered
|
RR, I just started trying a new Kwikfish method that I've been using with excellant success on Warts for a few years now. Remove the 2 stock hooks. Put a long 1 1/4" beadchain swivel on the belly eye and the large siwash on the end of the chain. Unlike the flapping of a rear hook setup, this enables the hook to stabilize right in the strike zone so the Kings usually get it in the mouth better. With the wildly swaying back hook the fish often miss it or are marginally hooked on the jawline skin or even on the outside of their face; thus a lot of lost Kwikfish hookups. Where it's legal to use a large treble, pushtwist a large piece of backer rod down over the treble hookshank, razor shape it like a torpedo, and put the hook on the beadchain. This will keep the heavier big treble closer to a neutral bouancy so as to keep the hook right in the strike zone when using it in a little slower water. I really think this is going to be the answer to a better % landing rate with Kwikies. Let us know how this works out for you fishermen with a post here; and a success ratio report e-mailed to me would be really appreciated. Thanks. - RT
|
Top
|
|
|
|
|
0 registered (),
1104
Guests and
5
Spiders online. |
Key:
Admin,
Global Mod,
Mod
|
|
11500 Members
17 Forums
72971 Topics
825632 Posts
Max Online: 3937 @ 07/19/24 03:28 AM
|
|
|